Furnace Repair in Burley, ID
Furnaces here run from September through June. If yours quits, tell us what it's doing and a licensed contractor who covers Cassia County will get in touch.
Tell us about the job
It takes about a minute.
Ten months of heat, and a grid that doesn't always hold
Your furnace runs from September through June here, ten months of the year. On winter nights that average 20°F from December through February, it cycles on and off for hours to hold the house steady. Most homes in the area heat with electricity, so the furnace needs power not just to light the burner but to run the blower and controls.
That power doesn't always hold. Idaho saw 11% of households lose power for 24 hours or more in 2024, and this area has logged 55 winter storms and 85 damaging wind events over the past ten years. When the power drops on a cold night, your furnace stops with it, and it should come back on its own once power returns. If it doesn't, something inside needs a look.
- 10 months
- September through June, your furnace is on duty
- 20°F
- the average winter night it heats against
- 55 winter storms
- in ten years, the nights a failure hurts most
NOAA nClimDiv, 1991–2020 normals
Idaho requires HVAC contractors to hold a state license.
The license belongs to the contractor, not to any single furnace repair. Idaho's HVAC Board issues that license, and it covers the business across every job it takes on rather than being tied to this one repair.
For a furnace, the dangerous part of the job is the gas connection. In Idaho, the contractor's license is what stands behind that work, since the Board that licenses HVAC contractors is the one accountable for who is allowed to do it.
Sources: Idaho Legislature · Idaho Division of Occupational and Professional Licenses
- Why won't my furnace turn on?
- Most often the thermostat isn't calling for heat, or the furnace isn't getting power. Check that the thermostat is set to heat and the temperature is above room temperature, and check the breaker. If those are fine, the igniter or the flame sensor may have failed, or the furnace could be locked out from a safety switch tripping. A licensed contractor can find which one it is and reset or repair it.
- Why is my furnace blowing cold air?
- The furnace may be running the blower without the burners lighting, which happens when the igniter or flame sensor has failed. It can also mean the furnace is stuck in a startup or cooldown cycle, when air blows before the burners fire or after they shut off. If cold air keeps blowing during normal running, something is stopping ignition and a contractor needs to check it before you run the furnace again.
- Why won't my furnace pilot light stay lit?
- A pilot light that won't stay lit usually means the thermocouple has worn out and can no longer sense the flame to keep the gas valve open. It can also mean a draft is blowing the flame out, or the pilot orifice is partly clogged. None of these clear up on their own, so a contractor will need to replace the part or clean the line.